Release the button when BMW CC-ID codes appear on the bottom display. Press BC button on the left stalk and hold it pressed for 5 seconds. Use left stalk to navigate to CHECK submenu. If you believe there is a problem with your car, you should have it scanned with an OBD-II code reader. Dismiss or wait for all warning and failure messages to disappear. Display will show -hfor high input with the ignition switch in the START positionand -L for low input with the ignition switchin the RUN position.PA-PE7not used.GAGERepeats the displaycycleTo exit the HEC Dealer Test Mode, turn the ignition switch to the OFF positionShort list of common Diagnostic Trouble Codes NOTE: DTC Codes are not to be used for diagnosing problems.
Battery voltagegauge will indicate present battery voltage.93-1026.2-9.1 volts, low voltage115-1248.5-10.7 volts, Normal band start215-22515.8-18 volts, Norm band end230-24116.9-19.1 volts, high voltagerhEoDisplays the presentdecimal rheostat dimming input, 0-255 (used when requesting assistancefrom the hotline)rhirhSrhoNot used.CrDisplays the currentRUN/START sense input. If you have a 2008 or newer sled with the multi-function gauge, just press and hold the MODE button and press the headlight HI/LOW beam switch repeatedly stop. The belt itself should have been replaced, which he didnt even know how to change after I had asked him, he told me he didnt have the owners manual, but it was under the seat, the coolant was a little low and should have been topped off, the plugs needed to be replaced.A low oil pressureor an inoperative engine oil pressure switch (less than 6 psi) willdisplay a value greater than 176.dEGCDisplay of enginetemperature in Degrees C input from cylinder head temperature sensor.49 C'C' mark60 CNormal band start120 CNormal band end-40 CNo SCP message for 5 secondsbAttDisplays the code(0-255) for the battery voltage input to the HEC. He told me they go right through the sleds to make sure they are ready to ride with no underlying problems, but after spending time with the sled I found that it hadnt been touched. The place I bought this sled at was Motorhead Trading Post in Sanford Maine, the owner is a slick talker but thats about it. Part 6 of 6: If the Check Engine Light returns. If the Check Engine Light comes back on, then there is still an issue with your car. sure enough, the fuse was blown, installed a fresh one and the light went right out. Step 5: Remove the scan tool and test drive the vehicle. You were right, checked dootalk, found a post about a shorting visor popping the accessory fuse and causing this issue. Reset Check Engine Light with Two Methods Turn off the vehicle, and put on safety gear necessary for handling a car battery.
0 kommentar(er)
